Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
I use a app_timer_create() function to create a task(200ms once)
when in the task_timeout_handle() ,
I do something more than 200ms,
what will this timer going ?
Before you ask your question, please remember to check if it is suited for Nordic Developer Zone, and that it has not been asked before. Please search Nordic Developer Zone, if you find your question,…
Nordic Semiconductor offer two gateways for asking questions about anything connected to their products, the MyPage support portal and Nordic Developer Zone. Questions in the support portal are only visible…
Comments to a question or answer should only be used to ask for more information or for clarification of a question or answer.
Edit your question or answer to be as good as possible, fix mistakes, improve…
Radio Notification
In this tutorial we will set up a beacon example and modify it to use radio notification. Then we will use radio notification to light a LED when the radio is transmitting.
While this…
Board Support Package
In this tutorial we will use the Board Support Package to control hardware peripherals on the nRF51 or nRF52 DK.
Required tools
Keil 5.20
nRF SDK 11nRFgo Studio 1.21.…
nRF51 Low power modes and power profiles documentation
The low power modes for the nRF51 series are System On and System Off. You can read about them in the nRF51 Series Reference Manual v3.0 sections…
###Note: This tutorial is for the legacy DFU module included in SDK version 11 and earlier. To get started with the new DFU included in SDK 12 and above, please see the SDK documentation in the Infocenter…
Before we begin
Table of context
Before we begin
The "Hello world" example
Advertising
RSSI
Addresses
Address types
Advertising types
Bonding
Advertising data
Scan response data
Change Log 2018…