Nordic DevZone

Overview The UriBeacon design allows a Bluetooth Low Energy (BLE) device to periodically transmit an ADV packet that contains a URI. This technology enables any device, place or thing to become a beacon…

Since nRF51 SDK version 8.0.0 SoftDevices binary files have become a part of the release. In order to make it easier to flash proper type and version of SoftDevice a new feature was added: each project…

When using nRF8001 with an Arduino board, Atmel Studio is a good free tool to use for development of your firmware. The following video shows a procedure in Atmel Studio in order to enable debugging of…

This blog series was created as an attempt to fill in the gap between how Bluetooth Smart is described in the spec and how you can use our APIs and event from our softdevice to do what defined in the spec…

Important updates: Due to erratum 84 (COMP: ISOURCE not functional), capacitive sensing using the relaxation oscillator method is not usable in a real product with the nRF52832, as it will only work reliably…

This blog series was created as an attempt to fill in the gap between how Bluetooth Smart is defined in the spec and how you can use our APIs and event from our softdevice to do what defined in the spec…

###Other relevant posts For an overview of current measurement basics, see this post: Introduction For a concise guide to setting up measurement equipment with the nRF52832 development kit, see this…

###Other relevant posts For an overview of current measurement basics, see this post: Introduction A post that describes how to measure current on the nRF52821 Engineering B with SoftDevice s132 v2…

###Other relevant posts A concise guide to equipment setup, and how to use the development kit for current measurements can be found here: Measuring current with PCA10040 v0.9.0 A post that describes…