Nordic DevZone

In SDK 12.0.0 or later, logging/debugging over RTT is built in to the logger module NRF_LOG. To enable logging over RTT, "check" the NRF_LOG_BACKEND_SERIAL_USES_RTT option in sdk_config.h in the configuration…

Hello. I was spending the last few days to implement an interface to access the BLE mesh via the Internet. The mesh consists of devices with LEDs, which then could be turned on and off in my browser.…

As many have noticed, Keil 5 does not have native support for Keil 4 projects (project files ending with uvproj), it only has native support for Keil 5 projects (project files ending with uvprojx). However…

→ Check out the preceding part of this tutorial series before starting on this: nRF Connect SDK Tutorial series - Part 0 This part of the nRF Connect SDK Tutorial series will be short and concise and…

→ Check out the preceding part of this tutorial series before starting on this: nRF Connect SDK Tutorial - Part 1 Welcome to the second part of this tutorial series. Now you know, to a small extent…

→ Check out the preceding part of this tutorial series before starting on this: nRF Connect SDK Tutorial - Part 2 This is the third and last part of this tutorial series and will go through some important…

Purpose The purpose of this blog is to show how to create a Zephyr application that boots from the MCUBoot bootloader.  We will also show how to update an application using the Device Firmware Update (DFU…

Scope This is a discussion on building a Bluetooth application on our new nRF Connect SDK/Zephyr platform with the reflections to our nRF5 SDK which is based on the SoftDevice Bluetooth stack. The goal is…

The purpose of this document is to give a brief introduction to AWS services, and explain how to connect to these services using nRF9160 devices and the MQTT protocol. The tutorial covers the necessary…