Hi there,
I would like to add some extra data to mesh-nodes, when not provisioned -- with ble_advdata_manuf_data_t usage. What is the best way to do it and where?
And...
Hi there,
I would like to add some extra data to mesh-nodes, when not provisioned -- with ble_advdata_manuf_data_t usage. What is the best way to do it and where?
And...
Communicating with Ultrasonic Distance Sensor HC-SR04 using nRF51-DK (nRF51822/nRF51422), and transmitting measured distance over BLE UART.
http://electronut.in/nrf51-hcsr04/
The nrf52832 is quite a competent System on Chip. Even with the long list of errata for the preview release this chip packs a punch.
I've been playing around with this chip for sometime now and have made…
Recently, there are a few queries from Japanese customers on nRF51 production.
Basically the expectations are
- Program the flash as a whole, including bootloader, application and soft device
- Target…
Radio Notification
In this tutorial we will set up a beacon example and modify it to use radio notification. Then we will use radio notification to light a LED when the radio is transmitting.
While this…
Board Support Package
In this tutorial we will use the Board Support Package to control hardware peripherals on the nRF51 or nRF52 DK.
Required tools
Keil 5.20
nRF SDK 11nRFgo Studio 1.21.…
nRF51 Low power modes and power profiles documentation
The low power modes for the nRF51 series are System On and System Off. You can read about them in the nRF51 Series Reference Manual v3.0 sections…
###Note: This tutorial is for the legacy DFU module included in SDK version 11 and earlier. To get started with the new DFU included in SDK 12 and above, please see the SDK documentation in the Infocenter…
Before we begin
Table of context
Before we begin
The "Hello world" example
Advertising
RSSI
Addresses
Address types
Advertising types
Bonding
Advertising data
Scan response data
Change Log 2018…