Nordic DevZone

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…

2020-08-04: The content of this guide is now covered in the documentation on Infocenter. For the most up-to-date Getting started guide with nRF9160 DK please follow this link.  2020-03-09: Updated tutorial to…

Inside every nRF9160 DK there is a eSIM from iBasis. Below is a FAQ related to iBasis global access for things. (Updated on November, 2020) eSIM Provisioning and Network Selection Logic Q. What is an…

The scope of this tutorial is to make it clear how a developer can adjust the RAM and FLASH memory start addresses. The examples demonstrated in this tutorial uses SDK 15.2 The first three Sections explains…

This tutorial demonstrates how to adapt and program SDK example applications to the nRF52840 dongle using USB DFU. It also describes how to program the dongle via Serial Wire Debug (SWD) using an external…

We are happy to announce our first release of the nRF Connect for Cloud Device API! Connect your BLE, LTE/NB-IoT or any other device to our free IoT development platform and interact with that device through…

This is a follow-up to my previous blog post; adding custom commands to a BLE example. I hope it was interesting to see an example of adding the vendor specific Nordic UART service (NUS) into another…