Nordic DevZone

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…

→ Check out the preceding part of this tutorial series before starting on this: nRF Connect SDK Tutorial series - Part 0 This part of the nRF Connect SDK Tutorial series will be short and concise and…

→ Check out the preceding part of this tutorial series before starting on this: nRF Connect SDK Tutorial - Part 1 Welcome to the second part of this tutorial series. Now you know, to a small extent…

→ Check out the preceding part of this tutorial series before starting on this: nRF Connect SDK Tutorial - Part 2 This is the third and last part of this tutorial series and will go through some important…

Purpose The purpose of this blog is to show how to create a Zephyr application that boots from the MCUBoot bootloader.  We will also show how to update an application using the Device Firmware Update (DFU…

Scope This is a discussion on building a Bluetooth application on our new nRF Connect SDK/Zephyr platform with the reflections to our nRF5 SDK which is based on the SoftDevice Bluetooth stack. The goal is…

The purpose of this document is to give a brief introduction to AWS services, and explain how to connect to these services using nRF9160 devices and the MQTT protocol. The tutorial covers the necessary…