Nordic DevZone

PDM stands for pulse density modulation. PDM is a form of modulation used to represent an analog signal with a binary signal. In a PDM signal, specific amplitude values are not encoded into codewords…

One of most frequently asked question from customers is howt to test RF to evaluate RF performance on their device. The precondition of this is to connect UART between PC and DUT(Device Under Test) prior…

This tutorial shows you how to get started with RIOT OS on nRF52832 using IPv6 over BLE communication. To fully understand this tutorial you will need to have minimum knowledge of Linux environment…

→ Check out the preceding part of this tutorial series before starting on this: nRF Connect SDK Tutorial series - Part 0 This part of the nRF Connect SDK Tutorial series will be short and concise and…

→ Check out the preceding part of this tutorial series before starting on this: nRF Connect SDK Tutorial - Part 1 Welcome to the second part of this tutorial series. Now you know, to a small extent…

→ Check out the preceding part of this tutorial series before starting on this: nRF Connect SDK Tutorial - Part 2 This is the third and last part of this tutorial series and will go through some important…

Purpose The purpose of this blog is to show how to create a Zephyr application that boots from the MCUBoot bootloader.  We will also show how to update an application using the Device Firmware Update (DFU…

Scope This is a discussion on building a Bluetooth application on our new nRF Connect SDK/Zephyr platform with the reflections to our nRF5 SDK which is based on the SoftDevice Bluetooth stack. The goal is…

The purpose of this document is to give a brief introduction to AWS services, and explain how to connect to these services using nRF9160 devices and the MQTT protocol. The tutorial covers the necessary…