Hello,
I keep getting very strage intermittent (well when it happens its permanent) errors with nrf54L15DK.
I have not yet observed it with my custom PCB (based on Raytak...
There are several types of write operations, write request with authorization, write request without authorization and write command. You can see message sequence charts for those messages here and he…
Here is an example of a hardware setup to measure the voltage on a Lithium battery with a voltage divider and a connected capacitor. The Lithium battery typically has a voltage range of 2.7 - 4.2 V and…
I've put up on Sourceforge, a Mac OSX application which interfaces with the Nordic BTLE sniffer software and has some of the functionality of the Windows application Nordic ships with that software package…
Introduction
Intention of this guide is to clarify and describe main aspects relevant for nRF9160 GNSS receiver functionality, build configurations, tool recommendations and how to get started with the…
Background
There is a need to enable Nordic hardware with the Direct Test Mode (DTM) firmware. This is so the physical layer and RF characteristics may be ascertained as set in the Bluetooth Sig Specification…
Requirements
This document uses:
Segger Embedded Studio (SES)
nRF5 SDK v17.1.0
an nRF52 DK to emulate the nRF52810
a BLE-enabled mobile device
You may want to review the blog here for a more comprehensive…
Requirements
This hands-on tutorial uses:
Segger Embedded Studio (SES)
nRF5 SDK v17.1.0
an nRF52840 DK
a BLE-enabled mobile device
You can use an nRF52 DK or nRF52833 DK instead of the nRF52840 DK,…
This is part 3 of the series Building a Bluetooth application on nRF Connect SDK
You can find other parts here:
Part 1 - Peripheral Role.
Part 2 - Central Role.
In Part 1 we covered the generic architecture…
Purpose
The purpose of this guide is to demonstrate the use of Bluetooth Shell. Bluetooth Shell (BT Shell) is a command-line shell application that runs over the UART. It allows one to manually type in…
