MFW 1.3 Reset Loop

RE: MFW 1.3 Reset Loop

user5573 — Fri, 27 May 2022 00:51:26 GMT

BTW, can use %XFACTORYRESET to clear reset loop

user75759 — Mon, 14 Jun 2021 08:02:59 GMT

Thanks for your help Heidi!

Heidi-Irene Harvey Sollie — Mon, 14 Jun 2021 07:27:58 GMT

Hi, I misunderstood as well. I have edited my initial comment.

There is no way to turn off the reset loop detection feature nor to go around it.

I will suggest this to the team for future MFW releases.

Best regards,

Heidi

user75759 — Fri, 11 Jun 2021 01:53:40 GMT

Sorry my misunderstanding, I thought you were saying you could cut the half hour short by issuing AT+CFUN=0.

Might I suggest that in future versions this feature can be disabled/enabled until %XPRODDONE is set?

Heidi-Irene Harvey Sollie — Thu, 10 Jun 2021 13:16:45 GMT

Hi,

Please note that the restriction time does not elapse if there is no power in the device.

Are you turning off the device at any point in the reset loop?

user75759 — Thu, 10 Jun 2021 08:45:55 GMT

Thank you Heidi,

I've tested and this does not get you out of the loop, it only does so if you wait the half hour?

Heidi-Irene Harvey Sollie — Thu, 03 Jun 2021 11:24:22 GMT

Hi!

No there's no way to disable the feature. You can get out of the reset loop by running AT+CFUN=0.

Correction: there is no way to get out of the reset loop either.

However, if the user cuts power without the modem in offline mode (+CFUN=0), the restriction timer starts all over again in the next power-up.

Best regards,

Heidi