Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
Hi,
I need to record audio using ICS43434 and then process the recorded audio with nrf5340. Then I need to write the file to the flash memory. I need to know is it possible...
Hi,
I have noticed some strange issues with the modem part while developing. Sometimes the Modem is not connecting to network anymore. Our code has a loop that uses
lte_lc_offline...
Hello, All,
I want to use the GPS positioning function of the nRF9160, currently using the "nrf/samples/nrf9160/gnss" sample for testing, the type used is GNSS_SAMPLE_ASSISTANCE_NONE...
Hi.
Hope someone could help me on how to scan and parse the Manufacturer Specific Data that comes after the Company ID. I am using zephyr with nRF52840.
Thanks!
I am using nrfutil version 5.2.0 on a Mac Pro M1, running Mac OS Monterey 12.1. I get the following error when I try to generate a private key
------
Us-MacBook-Pro...
I just bought an actinius icarus board, and am trying to connect to it on linux (or windows),
The problem is that when I plug in the board in the usb, it will only appear...
Hi
1、Becuse of customer's PC administrator has been implanted managed software in the engineer's computer，So the m anaged software may limit some processes in the computer...
Hi,
After upgrade from nRF Connect SDK 1.4.1 to SDK 1.7.1 we have seen an increase of the current consumption with about 100uA.
Before with SDK 1.4.1 the idle current...
The non-standard function mlme_rx_enable declared in the header mac_mlme_rx_enable.h does not seem to be defined in 802_15_4_lib_gcc.a.
The compilers throws an error: undefined...
Hi all,
I'm trying to put the system into the SYSOFF mode when the device detects an external charger. HW-wise it's implemented by the charge controller pulling a GPIO HIGH...
Hello,
Let me just briefly state that I have referred to required documentation and also executed spi_transceive_async() test, at zephyr\tests\drivers\spi\spi_loopback...
Hi,
I'd like to generate code for the Adafruit nRF42850 Feather Express board using Visual Studio Code, and then transfer that code using the existing bootloader (that comes...
Hi
I want to use nrf52840 to develop a central like figure below，the central can connect and communicate with all kinds of peripheral. Is there a reference example？
