Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
Hello,
I made a project based on the usbd_ble_uart_freertos example and added peer manager for secure connections.
It works in a way that someone can open the uart port...
hello,
i am using nrf52832 with lis3dh accelarometer and max30205 temperature sensor in our customised board with sdk 15.2 in my driver for temperature sensor i am using...
Hi,
I have developed an App to connect and communicate with a BLE peripheral. I used the nRF52840 device. Now I would like to change the firmware so that only my App can...
Hi, I am working with nrf9160, I want to convert INT64 timestamp value to CHAR array with sprintf. I use %lld but sprintf said only "ld" if I use %ld it convert only low side...
I have experimented with asset_tracker_v2 sample application using Cat Tracker sample in AWS. In addition I have created my own application which uses the same JITP certificate...
Hi, we have downloaded the latest nRFtoolbox for iOS from Github.
It compiles fine except it won't upload to our device or simulators.
We get this message:
The package...
Hi,
SDK: 14.2 Software device:332(5.0.0)
I want to use a bootloader to update my APP image. So I use DFU example and change some setting as below
/components/softdevice...
I have just installed VS Code and was following the videos for building an application. My board does not show up on the nRF Connect tab connected devices. The status bar...
I have been attempting to install nRF Connect SDK on macOS for several months without complete success. You can check my prior tickets for details. Nonetheless, I have recently...
Dear Members,
I can use a simple timer in :
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter.sdk5.v15.0.0%2Fnrf_dev_simple_timer_example.html...
I use my customized antenna board (5 antennas on it) with the following IQ problem:
DF3 CTE[0]: samples count 45, cte type AOA, channel index 13, slot durations: 2 [us]...
HI
I am using nrf52840 and I want to merge nrf_calendar and app_ble_uart example, added ssd1306 oled 128x32 spi and mpu6050 as well,
but the error is from nrf_calendar...
which version of embedded segger studio do i have to download from the link ? www.segger.com/.../ ----> i am new for embedded-studio , so when i browse to the download page...
