Hi Team,
To implement iBeacon what are the things to be take care at the peripheral side.
Whether the code for advertising the peripheral in "CoreBluetooth" and "CoreLocation...
Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
In SDK 1.9.0 i saw that QSPI deep power down was implemented and i can confirm that that works using the below code. The issue I see is that if the device is in deep power...
Hi,
Is there any sample/example that comes with SDK that shows how to add extended data in BLE advertisement (using Zephyr)?
I have tried adding some additional bytes...
We have 3 nRF52840 to establish a net. one for master device, One for Master device, One for HUB(Msater-Slave) device, and One for Slave device. The data flow is Slave device...
Hi,
Following the update of my mac (M1) in Monterey, i can no longer flash programs on my board (everything worked under Big Sur).
I got the error JLinkARM DLL load...
Hello,
I am currently trying to add a FEM (nRF21540) to an already existing BLE project that is using nRF5 SDK. For that purpose I ordered the nRF21540 DK that is using...
Hello, I developed for my customer, a ZigBee coordinator in last 2019, using nRF5 SDK for Thread and Zigbee v3.2.0. Now my customer ask me if it possible to have the LQI value...
Hi,
My goal is to use a timer to trigger SPI transactions and the spi_event_handler() to trigger bluetooth transfers. In order to make it as fast as possible, I would...
Hello, we're trying to make products using BLE with nRF52840(central) and nRF52833(peripheral).
We did make custom boards and also made a program that once paired(bonded...
Hi all,
I'm working with a pressure sensor (LPS22HBTR) and the nRF52-DK and I have some issues when sending data through BLE (nRF52832). When I run the program without...
I have recently upgraded from NCS 1.5.0 to 1.8.0 and noticed that the native TLS stack (vanilla mbedtls) was no longer being used for TLS based sessions.
My use case requires...
Hi,
I found the online power profiler for BLE ( Online Power Profiler for Bluetooth LE - opp - Online Power Profiler - Nordic DevZone (nordicsemi.com) ), it helped me to...
I was working with VS code just fine and then upon booting it up today suddenly nothing will build anymore including sample projects. the only thing that i could tell that...
hello Nordic
i am working with nrf52840, with zephyr 2.6.9, ncs 1.7.1
i want to have an interrupt on a pin toggle and have a callback for up and one for down
i configure...
