Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
Hello,
I'm having an issue with setting up the I2C communications on the nRF9160. When trying to compile a program with an I2C bus but even when I attempt to compile the...
Hi,
does any of the readers here have some good idea, as how to give the plenty of nordic eval boards on the desktop some kind of housing, to protect them from short cuts...
Hi,
1. we are referring the example code for the BLE how the pairing is happening and where this ( passkey_display ,cancel ,pairing_complete ,pairing_failed ) callbacks...
Good day, I would like to confirm the following points regarding the nRF9160 and nRF5340: nRF9160 1. The modem firmware binary is programmed through the SWD and not a UART...
Is there any Kconfig line to set the TX_POWER on the prj.conf file?
Also are the values listed on the below value also valid for the nRF52832 micro.
developer.nordicsemi...
Hey,
I am trying to add DFU support to my application.
In my case, I copied the code from the NRF SDK 15.3 DFU secure_bootloader example for pca10040_ble and included...
Hi ,
few years ago our team has developped a scorer point for tennis based on your nRF24L01P-T (ricever and transmitter). The transmitter is in the player's cuff with a...
Hi there,
We intend to interface nRF52810 with STM32. While there is documentation available
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter...
How can I create a new nRF Connect SDK project from a sample using Segger Embedded Studio?
My idea is to get the settings and libraries right, but replace the actual application...
I’m working on code for a custom board which has an nRF9160 SIAA B1 version. I have a couple earlier boards which use the nRF9160 SICA B0 version. On the older boards, I have...
Hi everyone, i have working for a few days trying to implement the fds module, i have followed the "flash_fds" example but i am struggling a lot trying to make this work....
Have flashed github's bluetooth code onto the nrf52840 DK kit and then tried to scan the available devices using android based mobile, in that bluetooth device name is not...
