Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi,
This post is just to share with all of you (who would need it) a simple application interface (attached here) that uses the nRF52840 USB since we spent some painful...
Hi,
I am conducting a mesh test and it contains:
An android smartphone,
- running nrf mesh 3.1.7 on github
- sending hundreds of bytes packets to the mesh nodes...
Hi,
I am completely new with the development kit nRF5340, I have plugged in the USB and turn it ON, the status after that as follows,
- LED5 is blinking continuesly
...
Hi I have been doing some current consumption measurements using Nordic's Power Profile Kit 2.
The device I am measuring is a custom BLE device that uses the ADC to sample...
Hello, I'm having problems to debug my application when I check the "Enable debug options" in the build configuration. If I don't check this box, I can debug, however, most...
Hello,
I'm working with a little project in NCS 1.9.1, chip is NRF52805 acting as central, connecting to a peripheral that requires passkey and L3 security. Everything works...
Hello,
We are developping based on SDK 15.2 for nRF52 using IAR 8.11 and S132 V6.1.0 as softdevice for central/peripheral application. Bellow is the test scenario explained...
Hello,
I have an application where I send the data I receive over UART, directly to a phone connected with BLE. However, the BLE connection is often not fast enough to send...
I am using nRF52840, SDK16.0.0, Keil v5.18a to developing application. When I changed heap size in Keil C/C++ option, it failed! It can be successful if you change heap size...
Mr Jared, I am sorry. I accidentally pressed the verify button and the ticket(Case ID: 288462) was closed.
To answer your earlier question.
I checked the nrf_drv_rtc_cc_set...
Hello,
I would like to use the UICR customer registers to store our devices serial numbers.
Can you please point me to some example code for nRF52833 SoC.
I am using...
Hallo,
As I am developing a new product (peripheral acceleration sensor device) I would like to update the DIS service data with the following characteristics, Manufacturer...
Hi,
My BLE-Mesh client model sends an opcode to retrieve the server model state, When server model receives the opcode, relevant handler gets triggered from where I need...
Hello there,
I have looked through all of the various other related questions, but still cannot resolve this issue. I am trying to use RTT versus a UART for the console...
Hi. I'm using NCS v1.9.1 with nRF5340 and I'm trying to merge the direct_test_mode sample app with the hci_rpmsg sample app. Basically, I have one net core image that has...
