Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
In SDK 1.9.0 i saw that QSPI deep power down was implemented and i can confirm that that works using the below code. The issue I see is that if the device is in deep power...
Hi,
Is there any sample/example that comes with SDK that shows how to add extended data in BLE advertisement (using Zephyr)?
I have tried adding some additional bytes...
We have 3 nRF52840 to establish a net. one for master device, One for Master device, One for HUB(Msater-Slave) device, and One for Slave device. The data flow is Slave device...
Hi,
Following the update of my mac (M1) in Monterey, i can no longer flash programs on my board (everything worked under Big Sur).
I got the error JLinkARM DLL load...
Hello,
I am currently trying to add a FEM (nRF21540) to an already existing BLE project that is using nRF5 SDK. For that purpose I ordered the nRF21540 DK that is using...
Hello, I developed for my customer, a ZigBee coordinator in last 2019, using nRF5 SDK for Thread and Zigbee v3.2.0. Now my customer ask me if it possible to have the LQI value...
Hi,
My goal is to use a timer to trigger SPI transactions and the spi_event_handler() to trigger bluetooth transfers. In order to make it as fast as possible, I would...
Hello, we're trying to make products using BLE with nRF52840(central) and nRF52833(peripheral).
We did make custom boards and also made a program that once paired(bonded...
Hi all,
I'm working with a pressure sensor (LPS22HBTR) and the nRF52-DK and I have some issues when sending data through BLE (nRF52832). When I run the program without...
I have recently upgraded from NCS 1.5.0 to 1.8.0 and noticed that the native TLS stack (vanilla mbedtls) was no longer being used for TLS based sessions.
My use case requires...
Hi,
I found the online power profiler for BLE ( Online Power Profiler for Bluetooth LE - opp - Online Power Profiler - Nordic DevZone (nordicsemi.com) ), it helped me to...
I was working with VS code just fine and then upon booting it up today suddenly nothing will build anymore including sample projects. the only thing that i could tell that...
hello Nordic
i am working with nrf52840, with zephyr 2.6.9, ncs 1.7.1
i want to have an interrupt on a pin toggle and have a callback for up and one for down
i configure...
