Hi,
I am a bit confused about power consumption when using app_uart_fifo. To save power I put MCU to sleep in between each sent and received byte by using __WFE and __SEV...
Hi! I am building an android app for my project. I am using Proximity , UART and DFU from nrfToolbox app. I have 3 buttons on my home screen dedicated for each of them. I...
Dear Nordic employee:
1、 what do I have?
I have a thingy52 develop kit（nrf52832）
2、what is my purpose?
the quality of thingy52 audio demo is not good（iphone7）...
Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
Hi again,
The previous issue is closed - but I never got any suggestions or answers to my problem.
I still have this problem - if I do a prestine build the mcuboot doesn...
I’m having nRF52805 on a custom board (for our own application) using SDK 17.1.0 v7.2.0 S112 ( IDE: Segger Embedded Studio). Given the amount of memory this chip has (192...
Hello, I have a custom board with nrf52 module, one memory, one accelerometer and one gyroscope (the memory is the same used in your ev. board PCA10056).
I combine the examble...
Hi,
Adding the line of code below with app_timer_create causes the code to hang.
static void my_bat_timer_handler(void * p_context) { pulse_pin(LED); }
APP_TIMER_DEF...
Hi Community,
i recently migrated from sdk16 to sdk17 and I am using FreeRTOS.
My goal is to catch pin interrupts which already worked before migrating. Now I have the...
Hi,
I am testing the ble_uart_send function. I found the advertising was OK, but when my phone connected to the board, it stalled but no error was shown. I enabled DEBUG...
Hi all,
I am trying to send data from nrf52840 to Arduino. I have a simple UART program running on nrf52840 that is supposed to transmit a character to another device(Arduino...
Hi All,
Hope everyone is fine.
I'm using Vs code with nrf Connect sdk v1.9.1 to develope firmware for nrf52833.
Here our device has no display or Keyboard to give input...
I am doing some profiling with the peripheral_uart sample. It works as expected when I send small pieces of data, but when I start running a lot through it I get a crash....
Hi,
I am working on BLE on nRF52833dvk, am able to execute the sample example . I have one of the requirement, that I need to write the unit test cases for Bluetooth for...
Hi
I would like to use power management module with CAF. I got it somehow working and the device is going to poweroff or standby mode and wakes up, if i push some button...
Hi all
I'm developing a BLE application using nRF52832 : SDK 17.xx
My SW is based on the project ble_app_gls as I need to use a PASSKEY
I experience 2 difficulties ...
