I would like to test the newly added v4.2/v5.0 Bluetooth features (e.g. LE Secure Connections, Data Packet Length Extension, 2xSpeed, etc) against non-nordic devices. I have...
I am working on a project using a ble nano (nrf51822) using the Nordic SDK 8.1. In the examples I found a way to control an LED using the methods LEDS_ON and LEDS_OFF. I wanted...
Hello,
I am using ble_app_gls example and I have implemented static passkey in the code. Now I want to see if wireshark shows the passkey when I connect to ble devices. For...
Hi Team,
We are implementing an UART communication between a M4 processor (UART master) and a nRF51 (UART slave) and we want to use the UART in Low Power mode with flow...
Hello everybody,
for my project, i will bond the peripherial with the central.
I test my device with the MCP and can connect without problems. When i press the Bond Button...
Hi all,
I am trying to count the positive edges of a 3.5MHz signal with GPIOTE, PPI and the TIMER1. Unfortunately i can only measure to frequencies up to a little more...
Loaded Softdevice S140, ( Using NRF52840 DK board ) using NRFgo Studio.
App flash base is set to 0x00021000 and app RAM base is set to 0x20003000
Looking at the CPU...
Hello,
I'm having an issue with setting up the I2C communications on the nRF9160. When trying to compile a program with an I2C bus but even when I attempt to compile the...
Hi,
does any of the readers here have some good idea, as how to give the plenty of nordic eval boards on the desktop some kind of housing, to protect them from short cuts...
Hi,
1. we are referring the example code for the BLE how the pairing is happening and where this ( passkey_display ,cancel ,pairing_complete ,pairing_failed ) callbacks...
Good day, I would like to confirm the following points regarding the nRF9160 and nRF5340: nRF9160 1. The modem firmware binary is programmed through the SWD and not a UART...
Is there any Kconfig line to set the TX_POWER on the prj.conf file?
Also are the values listed on the below value also valid for the nRF52832 micro.
developer.nordicsemi...
Hey,
I am trying to add DFU support to my application.
In my case, I copied the code from the NRF SDK 15.3 DFU secure_bootloader example for pca10040_ble and included...
Hi ,
few years ago our team has developped a scorer point for tennis based on your nRF24L01P-T (ricever and transmitter). The transmitter is in the player's cuff with a...
Hi there,
We intend to interface nRF52810 with STM32. While there is documentation available
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter...
How can I create a new nRF Connect SDK project from a sample using Segger Embedded Studio?
My idea is to get the settings and libraries right, but replace the actual application...
I’m working on code for a custom board which has an nRF9160 SIAA B1 version. I have a couple earlier boards which use the nRF9160 SICA B0 version. On the older boards, I have...
Hi everyone, i have working for a few days trying to implement the fds module, i have followed the "flash_fds" example but i am struggling a lot trying to make this work....
Have flashed github's bluetooth code onto the nrf52840 DK kit and then tried to scan the available devices using android based mobile, in that bluetooth device name is not...
