I'm using an nRF52 (SDK11.0.0, s132) and am able to generate a hex and axf via Keil/uVision. It uploads and works just fine using a Segger J-Link. I want to try some lower...
Hi, I'm a newbie to Nordic and need to use multiple nRF24LE1s to get ADC values and transmit them to a single nRF24L01 connected to an Arduino. I need sample Keil compiler...
HI:
i hava a sender and it send a frame every 15ms ,not use any protocol,and reciver code like as follow:
while (1) {
Rf_StartRx(ReciverSC.RfBufPointer...
Hi to everyone,
i have an mb39c811-evsk-02 and over it there is a tmp102 temperature sensor and an nrf51822.
I want to read the values of the sensor over a beacon app. ...
Hi,I'm glad you can see my post.
Now, I am in a program to read and write FLASH such as the screenshot in the attachment.
Then I update with DFU service for the equipment...
Hi Is it possible to change the MTU size with the Master Control Panel?
I am making a ble device on a nrf52 with the SDK 12 (latest softdevice) which has the ability to...
Is there a function like battery_level_in_percent for AA battery?
I know battery_level_in_percent is only for CR2032.
Even though I compensate it to make it 3V from AA battery...
Hi again,
The previous issue is closed - but I never got any suggestions or answers to my problem.
I still have this problem - if I do a prestine build the mcuboot doesn...
I’m having nRF52805 on a custom board (for our own application) using SDK 17.1.0 v7.2.0 S112 ( IDE: Segger Embedded Studio). Given the amount of memory this chip has (192...
Hello, I have a custom board with nrf52 module, one memory, one accelerometer and one gyroscope (the memory is the same used in your ev. board PCA10056).
I combine the examble...
Hi,
Adding the line of code below with app_timer_create causes the code to hang.
static void my_bat_timer_handler(void * p_context) { pulse_pin(LED); }
APP_TIMER_DEF...
Hi Community,
i recently migrated from sdk16 to sdk17 and I am using FreeRTOS.
My goal is to catch pin interrupts which already worked before migrating. Now I have the...
Hi,
I am testing the ble_uart_send function. I found the advertising was OK, but when my phone connected to the board, it stalled but no error was shown. I enabled DEBUG...
Hi all,
I am trying to send data from nrf52840 to Arduino. I have a simple UART program running on nrf52840 that is supposed to transmit a character to another device(Arduino...
Hi All,
Hope everyone is fine.
I'm using Vs code with nrf Connect sdk v1.9.1 to develope firmware for nrf52833.
Here our device has no display or Keyboard to give input...
I am doing some profiling with the peripheral_uart sample. It works as expected when I send small pieces of data, but when I start running a lot through it I get a crash....
Hi,
I am working on BLE on nRF52833dvk, am able to execute the sample example . I have one of the requirement, that I need to write the unit test cases for Bluetooth for...
Hi
I would like to use power management module with CAF. I got it somehow working and the device is going to poweroff or standby mode and wakes up, if i push some button...
Hi all
I'm developing a BLE application using nRF52832 : SDK 17.xx
My SW is based on the project ble_app_gls as I need to use a PASSKEY
I experience 2 difficulties ...
