Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello everyone,
I am working on an application where I am using the BLE Nordic UART service (NUS) with a changed service UUID. I need to be able to uninitialize the service...
Dear ,
I am using nrf52833dk with NCS1.7.0 SDK.
Is there any flag or register value that I could use to determine if the device has been connected via USB? Or I can only...
I working on Asset_tracker_v2. I found in the project :
target_sources_ifdef(CONFIG_CLOUD_MODULE app PRIVATE ${CMAKE_CURRENT_SOURCE_DIR}/cloud_module.c)
in file at
C...
Hello!
I was just wondering if it is possible to use multiple encoders at once with the QDEC driver? Can you initialize multiple encoders on different pins or do you have...
Hi,
I use self bord with nrf5340 on it.
i started with project "central_and_peripheral_hr" and added CMSIS v2 and EVENT MANAGER configuration.
The i configured interrupt...
Hi,
I am using the nrfx GPIOTE driver to manage the output, input and interrupt on a nRF5340 on top of Zephyr Framework.
I know I can use the GPIO Api from Zephyr, but...
Hi,
I want to disable firmware signed key validation from mcuboot, when it validates a new image available through DFU.
Kindly suggest how to disable key validation from...
Hello,
I've been testing the AWS IOT app and ran into an issue where sometimes I see error -95, EOPNOTSUPP, on a connection when I am sending data to AWS. When I run the...
im trying to use the uart functionality in another project. i implemented uart using the uart example project and i got it working. the next stage is that i want to implement...
Hello,
I am developing with reference to "Light switch example". I am verifying communication reliability with one server and one client. Communication failure occurs with...
Hi
I am using nRF9160dk board.
I started with the aws_iot example, compiling it within VS Code.
I set up my board as a ‘thing’ in Amazon’s AWS, along with policy,...
Hello,
I recently started looking through the Smart Remote 3 code as I'm interested in potentially using a suitable nRF device + I2S ADC to encode and stream music using...
Sometimes when trying connection library raises TypeError unexpectedly. See logs below.
This does not reproduce every time, just randomly. Any suggestion about what...
