Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello,
I'm having an issue with setting up the I2C communications on the nRF9160. When trying to compile a program with an I2C bus but even when I attempt to compile the...
Hi,
does any of the readers here have some good idea, as how to give the plenty of nordic eval boards on the desktop some kind of housing, to protect them from short cuts...
Hi,
1. we are referring the example code for the BLE how the pairing is happening and where this ( passkey_display ,cancel ,pairing_complete ,pairing_failed ) callbacks...
Good day, I would like to confirm the following points regarding the nRF9160 and nRF5340: nRF9160 1. The modem firmware binary is programmed through the SWD and not a UART...
Is there any Kconfig line to set the TX_POWER on the prj.conf file?
Also are the values listed on the below value also valid for the nRF52832 micro.
developer.nordicsemi...
Hey,
I am trying to add DFU support to my application.
In my case, I copied the code from the NRF SDK 15.3 DFU secure_bootloader example for pca10040_ble and included...
Hi ,
few years ago our team has developped a scorer point for tennis based on your nRF24L01P-T (ricever and transmitter). The transmitter is in the player's cuff with a...
Hi there,
We intend to interface nRF52810 with STM32. While there is documentation available
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter...
How can I create a new nRF Connect SDK project from a sample using Segger Embedded Studio?
My idea is to get the settings and libraries right, but replace the actual application...
I’m working on code for a custom board which has an nRF9160 SIAA B1 version. I have a couple earlier boards which use the nRF9160 SICA B0 version. On the older boards, I have...
Hi everyone, i have working for a few days trying to implement the fds module, i have followed the "flash_fds" example but i am struggling a lot trying to make this work....
Have flashed github's bluetooth code onto the nrf52840 DK kit and then tried to scan the available devices using android based mobile, in that bluetooth device name is not...
