I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
pstorage_load and pstorage_clear appear to work fine, but whenever I do a pstorage_store the callback function is never called. This happens whether or not the Bluetooth unit...
Our USB keyboard using nrf24lu1p does not work on Mac OS 10.11.
Before Mac OS 10.11, USB keyboard was worked, but on Mac OS 10.11, it does not work.
I think your library...
In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq...
Hi again,
The previous issue is closed - but I never got any suggestions or answers to my problem.
I still have this problem - if I do a prestine build the mcuboot doesn...
I’m having nRF52805 on a custom board (for our own application) using SDK 17.1.0 v7.2.0 S112 ( IDE: Segger Embedded Studio). Given the amount of memory this chip has (192...
Hello, I have a custom board with nrf52 module, one memory, one accelerometer and one gyroscope (the memory is the same used in your ev. board PCA10056).
I combine the examble...
Hi,
Adding the line of code below with app_timer_create causes the code to hang.
static void my_bat_timer_handler(void * p_context) { pulse_pin(LED); }
APP_TIMER_DEF...
Hi Community,
i recently migrated from sdk16 to sdk17 and I am using FreeRTOS.
My goal is to catch pin interrupts which already worked before migrating. Now I have the...
Hi,
I am testing the ble_uart_send function. I found the advertising was OK, but when my phone connected to the board, it stalled but no error was shown. I enabled DEBUG...
Hi all,
I am trying to send data from nrf52840 to Arduino. I have a simple UART program running on nrf52840 that is supposed to transmit a character to another device(Arduino...
Hi All,
Hope everyone is fine.
I'm using Vs code with nrf Connect sdk v1.9.1 to develope firmware for nrf52833.
Here our device has no display or Keyboard to give input...
I am doing some profiling with the peripheral_uart sample. It works as expected when I send small pieces of data, but when I start running a lot through it I get a crash....
Hi,
I am working on BLE on nRF52833dvk, am able to execute the sample example . I have one of the requirement, that I need to write the unit test cases for Bluetooth for...
Hi
I would like to use power management module with CAF. I got it somehow working and the device is going to poweroff or standby mode and wakes up, if i push some button...
Hi all
I'm developing a BLE application using nRF52832 : SDK 17.xx
My SW is based on the project ble_app_gls as I need to use a PASSKEY
I experience 2 difficulties ...
