Hi, my friend,
I've been with nrf905. I use a 16-bit CRC check.
But I encountered problems in use:
1.Nrf905 16-bit CRC check format is CRC-16(IBM):X16+X15+X2+1 or other...
Hello,
I've built a small BLE-device based on the nrf8001.
With my Iphone I can discover this device and I am able to connect to it and listen to notifications of the...
Hey folks,
I'm trying to modify the SPI Master loop back example into a 4 line SPI Master_Slave program. Whenever I change the Tx_Buffer_lenght from 10 to lsome other numbers...
Hi.
I am using S130 softdevice version.
Basically, I am using NUS Service and make a my own NUS central service as NUS_C.
It is correctly work at normal state.
When...
Hi All,
Please Reviwe for a attached circuit file(Chip ANT of nRF51822.pdf).
I also attach a datasheet of chip antenna applied for that circuit(SDBTPTR3015 Data Sheet...
to me it made sense that EN_AA settings are controlling the receiving pipes if an ACK has to be sent back upon receiving a valid packet.
then i thought that the settings...
I am using BLE_Gateway example defined in nRF51-ble-bcast-mesh to create an rbc_mesh over 2 nRF51422 devices . For now, I am just testing it out on 2 nRF51422; I will set...
Hi again,
The previous issue is closed - but I never got any suggestions or answers to my problem.
I still have this problem - if I do a prestine build the mcuboot doesn...
I’m having nRF52805 on a custom board (for our own application) using SDK 17.1.0 v7.2.0 S112 ( IDE: Segger Embedded Studio). Given the amount of memory this chip has (192...
Hello, I have a custom board with nrf52 module, one memory, one accelerometer and one gyroscope (the memory is the same used in your ev. board PCA10056).
I combine the examble...
Hi,
Adding the line of code below with app_timer_create causes the code to hang.
static void my_bat_timer_handler(void * p_context) { pulse_pin(LED); }
APP_TIMER_DEF...
Hi Community,
i recently migrated from sdk16 to sdk17 and I am using FreeRTOS.
My goal is to catch pin interrupts which already worked before migrating. Now I have the...
Hi,
I am testing the ble_uart_send function. I found the advertising was OK, but when my phone connected to the board, it stalled but no error was shown. I enabled DEBUG...
Hi all,
I am trying to send data from nrf52840 to Arduino. I have a simple UART program running on nrf52840 that is supposed to transmit a character to another device(Arduino...
Hi All,
Hope everyone is fine.
I'm using Vs code with nrf Connect sdk v1.9.1 to develope firmware for nrf52833.
Here our device has no display or Keyboard to give input...
I am doing some profiling with the peripheral_uart sample. It works as expected when I send small pieces of data, but when I start running a lot through it I get a crash....
Hi,
I am working on BLE on nRF52833dvk, am able to execute the sample example . I have one of the requirement, that I need to write the unit test cases for Bluetooth for...
Hi
I would like to use power management module with CAF. I got it somehow working and the device is going to poweroff or standby mode and wakes up, if i push some button...
Hi all
I'm developing a BLE application using nRF52832 : SDK 17.xx
My SW is based on the project ble_app_gls as I need to use a PASSKEY
I experience 2 difficulties ...
