I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi, my friend,
I've been with nrf905. I use a 16-bit CRC check.
But I encountered problems in use:
1.Nrf905 16-bit CRC check format is CRC-16(IBM):X16+X15+X2+1 or other...
Hello,
I've built a small BLE-device based on the nrf8001.
With my Iphone I can discover this device and I am able to connect to it and listen to notifications of the...
Hey folks,
I'm trying to modify the SPI Master loop back example into a 4 line SPI Master_Slave program. Whenever I change the Tx_Buffer_lenght from 10 to lsome other numbers...
Hi.
I am using S130 softdevice version.
Basically, I am using NUS Service and make a my own NUS central service as NUS_C.
It is correctly work at normal state.
When...
Hi All,
Please Reviwe for a attached circuit file(Chip ANT of nRF51822.pdf).
I also attach a datasheet of chip antenna applied for that circuit(SDBTPTR3015 Data Sheet...
to me it made sense that EN_AA settings are controlling the receiving pipes if an ACK has to be sent back upon receiving a valid packet.
then i thought that the settings...
Hello,
I'm having an issue with setting up the I2C communications on the nRF9160. When trying to compile a program with an I2C bus but even when I attempt to compile the...
Hi,
does any of the readers here have some good idea, as how to give the plenty of nordic eval boards on the desktop some kind of housing, to protect them from short cuts...
Hi,
1. we are referring the example code for the BLE how the pairing is happening and where this ( passkey_display ,cancel ,pairing_complete ,pairing_failed ) callbacks...
Good day, I would like to confirm the following points regarding the nRF9160 and nRF5340: nRF9160 1. The modem firmware binary is programmed through the SWD and not a UART...
Is there any Kconfig line to set the TX_POWER on the prj.conf file?
Also are the values listed on the below value also valid for the nRF52832 micro.
developer.nordicsemi...
Hey,
I am trying to add DFU support to my application.
In my case, I copied the code from the NRF SDK 15.3 DFU secure_bootloader example for pca10040_ble and included...
Hi ,
few years ago our team has developped a scorer point for tennis based on your nRF24L01P-T (ricever and transmitter). The transmitter is in the player's cuff with a...
Hi there,
We intend to interface nRF52810 with STM32. While there is documentation available
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter...
How can I create a new nRF Connect SDK project from a sample using Segger Embedded Studio?
My idea is to get the settings and libraries right, but replace the actual application...
I’m working on code for a custom board which has an nRF9160 SIAA B1 version. I have a couple earlier boards which use the nRF9160 SICA B0 version. On the older boards, I have...
Hi everyone, i have working for a few days trying to implement the fds module, i have followed the "flash_fds" example but i am struggling a lot trying to make this work....
Have flashed github's bluetooth code onto the nrf52840 DK kit and then tried to scan the available devices using android based mobile, in that bluetooth device name is not...
