Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
I'm working on the nrf5340 with a modified sample found here ( main.c of the base sample here ) and nrf connect sdk 1.7.1
I see that adc_sequence_options .interval_us can...
I need to calculate the power consumption of a device. For this I purchased PPK2.
I use nRF52-DK for tests (there is the same microcontroller as we need).
The accelerometer...
Hi,
I am trying to utilise the available thread examples to build comms from CoAP server to external website through Border Router.
I have configured Border Router as...
Hi There,
I am presently running a BLE peripheral example on a custom board with SD Card data logging functionality, The SD Card library has worked fine until now , Since...
How to print a float value in segger embedded studio?
I am using nrf5_sdk17.1.0 version
I have used the below statement but it is outputting 0 only always.
NRF_LOG_INFO...
Hi,
I am using nrf52832 for a battery powered PIR sensor. I want the device to be awake only when in it detects motion. Can anyone guide me to use the lpn example in the...
I am using nRF52840 SoC for NCP/RCP application at the border router side, and nRF_Connect_SDK_v1.9.1 for NCP/RCP application development. My border router is my custom gateway...
Hey!
I want to try my SIM but I can't start the modem. Each command related to the modem that I execute gives me this error. I tried different firmware, but I can't upload...
I am looking for a BLE module to develop a product which will be used to track location and speed, with at least 2Hz frequency.
Requirements:
- Precision (location must...
Hello,
I would like to use the nRF5340 DK external debug port to program Thingy:91 as shown in Thingy:91's Getting started guide.
I believe that it is possible to use...
Hi
I want to use Sqrt() function from math.h but in my application it triggers some errors. Kindly guide me on how to properly include the math.h library into my application...
Dear Mr, Mrs
I was wondering how many flash size is left to the application firmware for a nrf52810 using both central & peripheral.
As far as I undestood, I need a s132...
Hi! I'm working on this particular project and the next step that I need to solve is connected to find a way to put in the same application the code of the GNSS example and...
