eUICC support - GSMA RSP M2M

Hi,

It is possible, but I would recommend that you contact your eUICC provider to ask how it should be performed.

If local profile assistance (LPA) is located on application domain, modem provides AT commands for generic and restricted UICC access. Application shall setup own logical channel, manage and communicate with required application(s) on eUICC via that channel. I would recommend that you contact your eUICC provider and ask specifically what is required to download the new profile.

Hi,

It is possible, but I would recommend that you contact your eUICC provider to ask how it should be performed.

If local profile assistance (LPA) is located on application domain, modem provides AT commands for generic and restricted UICC access. Application shall setup own logical channel, manage and communicate with required application(s) on eUICC via that channel. I would recommend that you contact your eUICC provider and ask specifically what is required to download the new profile.

Normally from the M2M eSIM management platform we will trigger an SMS based on which the device should open an HTTP channel via which the new eSIM profile should be downloaded.

Will the Thingy be able to process an SMS and initiated an HTTP session?

Hi,

That shall be supported.

If LPA is on eUICC the modem simply provides TCP socket for USAT BIP connection for transferring the profile. Also the SIM REFRESH procedure is supported for changing the profile.

Kind regards,

Håkon

From this video: https://youtu.be/Gs6rJlz4neQ?t=253

It depends on what type of eSIM one has ... "Costumer eSIM on eUICC" vs "M2M eSIM on eUICC" ... that is, who has the "full rights" to update the UICC Profiles on the eSIM.

Let's say we have a "Costumer" grade eSIM ... and we have in our Application made sure to connect to LTE and downloaded our new UICC Profile ...

How do we add / re-program the eUICC chip?

Do we need to connect our eUICC to the nRF9160 to a "special pin(s)"? ...

or the nRF9160 can do the update through the "Sim Card Interface"?

So basically as long as we have a removable eUICC and a data session we should be able to download a new profile and trigger the enable and refresh command.

Hi,

seludeft said:

How do we add / re-program the eUICC chip?

All communication is over the Sim Card interface.

Assuming consumer (not M2M eUICC), you access the SIM directly via the appropriate AT commands:

https://infocenter.nordicsemi.com/topic/ref_at_commands/REF/at_commands/mob_termination_ctrl_status/crsm.html?cp=2_1_3_8

https://infocenter.nordicsemi.com/topic/ref_at_commands/REF/at_commands/mob_termination_ctrl_status/csim.html?cp=2_1_3_9

I would recommend that you contact the eUICC provider to get details on how you should reprogram the specific eUICC using the standardized SIM communication channels that we provide.

Kind regards,

Håkon