How to configure I2C frequency 50k or lesser ?

Hi,

You can try 0x00C80000, which should give ~48.9 kHz. Note that other values than the ones listed in the register has not been tested or verified, and may not work correctly. The minimum supported bitrate in the TWI(M) peripheral is 100 kbps, so below this you are operating outside of spec.

Best regards,
Jørgen

~9.8 kHz = 0x00280000

~19.5 kHz = 0x00500000

~29.3 kHz = 0x00780000

~39.1 kHz = 0x00A00000

Thanks for your reply.

Please tell us your suggestion on I2C peripheral which is not detecting. What would be the cause?

Regards

Sudharsan

What have you tested to detect the peripherals?

Have you used the TWI scanner example to get the correct address of the connected peripherals? 

Are the peripherals powered correctly?

Have you verified that the peripherals work correctly with other I2C master?

Have you looked at the signals on the TWI bus with a logic analyzer, to see if the slave responds to the commands?

What have you tested to detect the peripherals?

Have you used the TWI scanner example to get the correct address of the connected peripherals? 

Are the peripherals powered correctly?

Have you verified that the peripherals work correctly with other I2C master?

Have you looked at the signals on the TWI bus with a logic analyzer, to see if the slave responds to the commands?

Thanks Jorgen. I will get back to you