Uart not working correctly when net core flashed by hci_rpmsg

Hi,

Could you set a breakpoint in the handler and read out the ERRORSRC register?

regards

Jared 

Hi Jared,

The uart I used is UARTE0(base addr 0x50008000), the offset addr of ERRORSRC register is 0x480, the value I read from addr 0x50008480 is 0xC.

That's a break and framing error. From product specification:

An ERROR event, in the form of a framing error, will be generated if a valid stop bit is not detected in a frame. Another ERROR event, in the form of a break condition, will be generated if the RXD line is held active low for longer than the length of a data frame. Effectively, a framing error is always generated before a break condition occurs.

What baud rate are you using? Is it the same on both sides?

That's a break and framing error. From product specification:

An ERROR event, in the form of a framing error, will be generated if a valid stop bit is not detected in a frame. Another ERROR event, in the form of a break condition, will be generated if the RXD line is held active low for longer than the length of a data frame. Effectively, a framing error is always generated before a break condition occurs.

What baud rate are you using? Is it the same on both sides?

I tested baud rate 9600 and 115200, and yes, both sides used the same baud rate at the same time. I found if BLE is not used, both 9600 and 115200 can worked well. But only 9600 can work after BLE flashed to net core. It is weird because I believe the uart signal is received by UARTE hardware, I don't understand why BLE has an influence on uart.

I tried to set HFXO with the code below:

NRF_CLOCK->TASKS_HFCLKSTART = 1;
while (NRF_CLOCK->EVENTS_HFCLKSTARTED == 0);
NRF_CLOCK->EVENTS_HFCLKSTARTED = 0;

Is there anything I can do?

Hi,

I can't see any clear connections between the Softdevice controller and the pins that you're using. I see that P0.31 is connected to LED4 on the development kit. Maybe the application running on the app core is toggling that LED? 

Could you try changing the RX pin to something else and see if it asserts?

regards

Jared