OTA Update Softdevice + Bootloader error

If you update the softdevice to a different version, you need to update the bootloader as well. The reason behind this behavior is that if you end up with a bootloader that doesn't use the correct softdevice version, then you have bricked the device (in case you don't have a debugger, which end products typically doesn't have). 

So you need to either do an app-only update, or you can do a SD+BL update, or a combination, APP-SD-BL.

dilbert168 said:

Do you think a old version Bootloader can be updated ??

If it is the standard bootloader from the SDK, then I think it should be fine. 

But as indicated in #1, if I try doing BL+SD, it returns "Response Code InsufficientResources"

Do you think any other setting I missed ?

Did you program the bootloader yourself, or was it pre-programmed when you got it? And if it was pre-programmed, can you erase it and program your own bootloader, or is that not an option?

BR,
Edvin

I was a pre-program device which requires a special cable (back order till April) to re-program with my own bootloader.

Also, I want to know whether I can just update it with OTA before I buy more of that unit.

dilbert168 said:

I was a pre-program device which requires a special cable (back order till April)

In that case, if we don't know what sort of bootloader that is on the device, then I don't know why it doesn't accept the image. Perhaps the new application is just too big, or it doesn't have the correct softdevice. Did it still say that when you used the --sd-req 0x00? If that doesn't work, I gess you can try to iterate throught the --hw-version, and see if it requires another --hw-version number. Or you can contact the one who wrote the bootloader that is flashed on the device and ask them how to use that particular bootloader. From my side, it will only be guessing.

BR,

Edvin.

dilbert168 said:

I was a pre-program device which requires a special cable (back order till April)

In that case, if we don't know what sort of bootloader that is on the device, then I don't know why it doesn't accept the image. Perhaps the new application is just too big, or it doesn't have the correct softdevice. Did it still say that when you used the --sd-req 0x00? If that doesn't work, I gess you can try to iterate throught the --hw-version, and see if it requires another --hw-version number. Or you can contact the one who wrote the bootloader that is flashed on the device and ask them how to use that particular bootloader. From my side, it will only be guessing.

BR,

Edvin.

Thanks.

The board supplier just reply me that using the cable is the only way   OTA is not supported in their bootloader.... may be version too old.

Well, if they don't know how to update it, then I don't think I can be of much help. Remember that I know nothing about this board, and nothing about their bootloader. If you can program it using a debugger, you can probably erase the bootloader and program your own. But without knowing anything about the board, it is difficult for me to say whether that is possible or not.

Best regards,

Edvin