I use SES(Segger Embeded Studio),but show error

Hello, 

The error will present itself in the output tab in SES. Please provide details on what is failing and what project you are trying to run.

Kind regards,
Øyvind

Dear Øyvind，

               I copied and pasted output for your reference.

Dear 

         I re-install the windows10 and tried again using cmd.exe.

it show error below:

-- Configuring incomplete, errors occurred!
FATAL ERROR: command exited with status 1: 'C:\Program Files\CMake\bin\cmake.EXE' '-DWEST_PYTHON=C:\Python310\python.exe' '-BC:\ncs\v1.6.1\zephyr\samples\basic\threads\build' '-SC:\ncs\v1.6.1\zephyr\samples\basic\threads' -GNinja

I also tried to use installing manually,but I found that I can't install GN meta-build system.

Becaues I can't open https://gn.googlesource.com/gn/#getting-a-binary in China.

This maybe the problem.

Hello, 

I'm very confused at the moment. 

The initial issue is building peripheral_lbs sample for the nRF5340DK. Correct? 

In the beginning you were using v1.9.0 of the nRF Connect SDK, but last messages you have reverted to v1.6.1. Please elaborate. 

liujirong888 said:

I also tried to use installing manually,but I found that I can't install GN meta-build system.

Becaues I can't open https://gn.googlesource.com/gn/#getting-a-binary in China.

This is not needed in the peripheral_lbs sample.

liujirong888 said:

FATAL ERROR: command exited with status 1: 'C:\Program Files\CMake\bin\cmake.EXE' '-DWEST_PYTHON=C:\Python310\python.exe' '-BC:\ncs\v1.6.1\zephyr\samples\basic\threads\build' '-SC:\ncs\v1.6.1\zephyr\samples\basic\threads' -GNinja

What samples did you try to build here? Please provide full build log.

Thanks. 

Kind regards,
Øyvind

Dear ,

         I found that v1.9.0 and v1.6.0 have same error.

both SDK I need to use.Attached build log for your reference.

Dear Øyvind,

            I mean that when I use SES or VS code error will show that create_nordic_project.py failed.

when I change to use cmd.exe to compile,it will show like this below, I use the sample "peripheral_lbs"

FATAL ERROR: command exited with status 1: 'C:\Program Files\CMake\bin\cmake.EXE' '-DWEST_PYTHON=C:\Python310\python.exe' '-BC:\ncs\v1.6.1\zephyr\samples\basic\threads\build' '-SC:\ncs\v1.6.1\zephyr\samples\basic\threads' -GNinja

Thanks for providing this information. 

Difficult to tell what is going on. I'm not able to reproduce on my side. Can you please provide the whole project folder that you are building? What configurations have you added? Please provide information from NCS v1.6.0 to narrow down issue.

Thanks. 

Thanks for providing this information. 

Difficult to tell what is going on. I'm not able to reproduce on my side. Can you please provide the whole project folder that you are building? What configurations have you added? Please provide information from NCS v1.6.0 to narrow down issue.

Thanks.