Need Sample ADC Program for (ADS1118) with NRF Dongle

Hi 

I am waiting for your reply.

Hi 

Sorry for the slow response. Håkon is currently unavailable, and I will help out in the mean time. 

There is no driver for the ADS1118 in either the nRF5 SDK or the nRF Connect SDK unfortunately, so you would need to implement this directly using the SPIM (spi master) driver. 

Fortunately the ADS1118 is a relatively simple sensor to interface, there is not a lot of different commands you need to send. 

A member of the community provided quite a lot of advice on interfacing the ADS1118 to an nRF device here, I would suggest you start by reading through that. 

Best regards
Torbjørn

Hi,

Thanks for the reply.

This Internal ADC SAADC program is useful for reading any type of sensor value. Is it possible right

Hi 

You can use the SAADC to read any analog value, yes, but make sure to read the documentation link I shared earlier to see that the SAADC specifications satisfy your requirements. 

I will summarize some of the key specifications here: 

- 12-bit maximum resolution

- 200 ksps maximum sampling rate

- You can not use any GPIO pin for the ADC, only those 8 that are labeled AIN0-AIN7

- The voltage has to be in the range of 0-VDD, you can not sample values below 0V or values above VDD

Best regards
Torbjørn

Ok sure, Thank you..

You welcome

Then I will consider the case closed, unless you have more questions. 

Best regards
Torbjørn

Hi,

Can you please provide me the ADC example code with Bluetooth for reading any sensor values

Hi,

Can you please provide me the ADC example code with Bluetooth for reading any sensor values