• State Verified Answer
  • Locked Locked
  • Replies 3 replies
  • Subscribers 25 subscribers
  • Views 171 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 288819
Options
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Upload code to external nrf52832 chip

user114519

Hi, I want to upload the code to external nrf52832 chip(which is on the custom-made PCB) using nrf52DK board.

First, I tried to check uploading the nrf52832 chip on nrf52DK board (nrf52DK-to-nrf52DK) using nrf52DK board following the figure below.

And it worked properly.

Next, I tried to upload external nrf52832 chip on my PCB with the same way. However, the error appeared.

I only soldered nrf52832 chip and tried to upload code. Should I assemble all the other parts(ex) crystal, inductor) to upload the code? 

Is there any solution for this, please?

 

Parents
  • +1

    Hi, most parts aren't necessary, but it's recommended to mount decoupling and VDD capacitors, and the DCDC components (if applicable) so the current flows as intended. Stuff like the external crystals shouldn't be necessary to mount.

    Best regards,

    Simon

Reply
  • +1

    Hi, most parts aren't necessary, but it's recommended to mount decoupling and VDD capacitors, and the DCDC components (if applicable) so the current flows as intended. Stuff like the external crystals shouldn't be necessary to mount.

    Best regards,

    Simon

Children
No Data
Related
Terms of service