How to include pre-processor directives in an SES Nordic Edition project?

Hello Mohammed,

In the SES-Nordic edition if you use project-->Configure nRF connect sdk project you will end up in a screen as shown below where you can load your file.

Kind Regards,

Abhijith

Hi Abhijith,

user115767 said:

In the SES-Nordic edition if you use project-->Configure nRF connect sdk project you will end up in a screen as shown below where you can load your file.

I thought the user can configure the project by selecting the appropriate options from the screenshot above. I looked for pre-processor settings but I could not find them.

Finally, can you please explain how each of the fields "Load", "Save As" and "Configure"  in the screenshot above are used?

Hi Abhijith,

user115767 said:

In the SES-Nordic edition if you use project-->Configure nRF connect sdk project you will end up in a screen as shown below where you can load your file.

I thought the user can configure the project by selecting the appropriate options from the screenshot above. I looked for pre-processor settings but I could not find them.

Finally, can you please explain how each of the fields "Load", "Save As" and "Configure"  in the screenshot above are used?

Hello,

Really sorry, but with Nordic SES edition and NCS it is not possible to add the preprocessor via nRF configuration option, if you open your file via Open nRf connect SDK project   (File-->open nRF connect SDK project... ). But if you are creating a new project from file option(File-->New Project), then you can see the preprocessor option. I tested it now and the previous answer was based on an older version(SDK). I have raised the question internally about whether there is any option to add preprocessor directives from SES IDE with NCS. My apologies if the last answer consumed your time a lot. You can add preprocessor directives by updating Cmake file.

Kind Regards,

Abhijith

Thank you Abhijith,

Could you please explain how each of the fields "Load", "Save As" and "Configure"  in the screenshot below are used?