Hello Team,
Could you please share some sample application or procedure to handle power modes (Sleep, Deep Sleep, etc) of the nrf9160.
Please let me know.
Regards, ...
Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
We have made a custom board with nrf52840-QFAA. In the nordic board folder in Zephyr sdk, I could only find .dts file for nrf52840-QIAA.
And there is only one soc...
I use the nRF52840-QIAA and in the datasheet are 2 different reference designs for the ANT pin. 3 or 4 component matching and filter network. When I calculate the impedance...
Hi.
I would like to build a FW image for the nRF5340 net core which includes the two mode BLE controller part and Radio Test (like in the Radio Test sample). These two modes...
Hello Team, We are looking to do a POC on LE audio feature. Could you please clarify below query on the product nRF5340 DK which supports LE audio? We are planning to buy...
Dear Bluetooth Mesh experts,
The Android app needs to monitor the accessibility of all mesh nodes. One way to implement it would be to add a ping message to the firmware...
Hi,
Automatic installation from ToolChain Manager, no errors. Perform west update ,no errors. Check all the files ,no problem found.
Have reinstalled NCS for many times...
Hi,
Using MeshSDKv5 on custom nRF and nRF52DK
We are working on an LPN wireless PIR sensor so which sends a sensor status publish message on occupancy.
I have notiiced...
Hi,
I´m making my own custom nrf52811 board, but I do have some questions about programming. I want to program it with the nrf52dk using p20.
Now I did read that 3v is...
I installed nRF Connect SDK v2.0.0 and notice that the open Segger Embeded Studio button is not shown.
Also (may be related) opening Segger Embeded Studio from the SDK v1...
Hi,
I followed the instruction on infocenter as bellow,everything goes well ,but the cc.composition_data_get() command,no composition data was received . Any missing steps...
I developed a custom board using nrf52810-qfaa, i edited pca10040e-s112(sdk17.1.0) and changed the advertising led to BSP_BOARD_LED_3, as i have only one led on my board at...
Hi,
I am trying to debug ESB packets with the following setup:
1. PRX (NRF52810)
2..PTX (NRF52810)
3. Sniffer (NRF52832) ( modified PRX so that it returns without...
