Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi,
This post is just to share with all of you (who would need it) a simple application interface (attached here) that uses the nRF52840 USB since we spent some painful...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
I am working on nRF52833 board (PCA10100). I am pairing my peripheral device ( Nordic Board ) to the Mobile Application. I have to disable pairing after a certain timeout...
Hi all,
It's my first post here so hello everybody!
I'm quite new in BLE5, but I have been playing with BLE4 some years ago (around 12) and I want to confirm some...
Hi Nordic
When I use JLINK to burn the firmware to the nRF52832 chip in the device, some devices cannot be programmed or cannot be programmed again after burning once
...
Hello, I've stumbled about a problem with the NrfConnect extension and Kconfig. It is quite simple: When a project directory contains a Kconfig file, it is used by west as...
I'm a bit confused by the "unidirectional" solutions offered as examples / documentation for the nRF5340 DK. I would like to build a BLE Audio headset that both receives and...
Hi
How is the ESB_EVT_IRQHandler started? NVIC_SetPendingIRQ(ESB_EVT_IRQ) is registered with on_radio_disabled(), but I don't know how to be started this handler in the...
Hi:
I use ncs 1.9.1, borad nRF9160-DK
sda-pin = <30>; scl-pin = <31>;
Config:
I added i2c2 in blinky, here is the source code.
I see i2c2 enabled in...
Hello,
I am experiencing issues with an nRF5340 DK. I would like to try the matter samples but every time I flash one of them, it results in fatal error and reseting loop...
fota_download_start copies the file but not host string into a static buffer. The comment implies that the download_client only requires this for the file path, though it...
Hello Devzone,
My name is Ted, and I recently came across a 2022 May 4 LPWAN Coverage document on one of Nordic Semi's technical guides. The specific guide is titled iBases...
