I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hi,
We have made a custom board with nrf52840-QFAA. In the nordic board folder in Zephyr sdk, I could only find .dts file for nrf52840-QIAA.
And there is only one soc...
I use the nRF52840-QIAA and in the datasheet are 2 different reference designs for the ANT pin. 3 or 4 component matching and filter network. When I calculate the impedance...
Hi.
I would like to build a FW image for the nRF5340 net core which includes the two mode BLE controller part and Radio Test (like in the Radio Test sample). These two modes...
Hello Team, We are looking to do a POC on LE audio feature. Could you please clarify below query on the product nRF5340 DK which supports LE audio? We are planning to buy...
Dear Bluetooth Mesh experts,
The Android app needs to monitor the accessibility of all mesh nodes. One way to implement it would be to add a ping message to the firmware...
Hi,
Automatic installation from ToolChain Manager, no errors. Perform west update ,no errors. Check all the files ,no problem found.
Have reinstalled NCS for many times...
Hi,
Using MeshSDKv5 on custom nRF and nRF52DK
We are working on an LPN wireless PIR sensor so which sends a sensor status publish message on occupancy.
I have notiiced...
Hi,
I´m making my own custom nrf52811 board, but I do have some questions about programming. I want to program it with the nrf52dk using p20.
Now I did read that 3v is...
I installed nRF Connect SDK v2.0.0 and notice that the open Segger Embeded Studio button is not shown.
Also (may be related) opening Segger Embeded Studio from the SDK v1...
Hi,
I followed the instruction on infocenter as bellow,everything goes well ,but the cc.composition_data_get() command,no composition data was received . Any missing steps...
I developed a custom board using nrf52810-qfaa, i edited pca10040e-s112(sdk17.1.0) and changed the advertising led to BSP_BOARD_LED_3, as i have only one led on my board at...
Hi,
I am trying to debug ESB packets with the following setup:
1. PRX (NRF52810)
2..PTX (NRF52810)
3. Sniffer (NRF52832) ( modified PRX so that it returns without...
