Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
Hi,
We have made a custom board with nrf52840-QFAA. In the nordic board folder in Zephyr sdk, I could only find .dts file for nrf52840-QIAA.
And there is only one soc...
I use the nRF52840-QIAA and in the datasheet are 2 different reference designs for the ANT pin. 3 or 4 component matching and filter network. When I calculate the impedance...
Hi.
I would like to build a FW image for the nRF5340 net core which includes the two mode BLE controller part and Radio Test (like in the Radio Test sample). These two modes...
Hello Team, We are looking to do a POC on LE audio feature. Could you please clarify below query on the product nRF5340 DK which supports LE audio? We are planning to buy...
Dear Bluetooth Mesh experts,
The Android app needs to monitor the accessibility of all mesh nodes. One way to implement it would be to add a ping message to the firmware...
Hi,
Automatic installation from ToolChain Manager, no errors. Perform west update ,no errors. Check all the files ,no problem found.
Have reinstalled NCS for many times...
Hi,
Using MeshSDKv5 on custom nRF and nRF52DK
We are working on an LPN wireless PIR sensor so which sends a sensor status publish message on occupancy.
I have notiiced...
Hi,
I´m making my own custom nrf52811 board, but I do have some questions about programming. I want to program it with the nrf52dk using p20.
Now I did read that 3v is...
I installed nRF Connect SDK v2.0.0 and notice that the open Segger Embeded Studio button is not shown.
Also (may be related) opening Segger Embeded Studio from the SDK v1...
Hi,
I followed the instruction on infocenter as bellow,everything goes well ,but the cc.composition_data_get() command,no composition data was received . Any missing steps...
I developed a custom board using nrf52810-qfaa, i edited pca10040e-s112(sdk17.1.0) and changed the advertising led to BSP_BOARD_LED_3, as i have only one led on my board at...
Hi,
I am trying to debug ESB packets with the following setup:
1. PRX (NRF52810)
2..PTX (NRF52810)
3. Sniffer (NRF52832) ( modified PRX so that it returns without...
