I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
I use 51822 to implement the HID touch device，It can works on android .But Tip Switch up is can't work again. This is my code touch_1012.rar
This is my test tool com.the511plus...
Hi guys,
I have a question about migration guide from the old 4.1.0 thread and zigbee sdk to 4.2.0.
The story is that I have this project running 4.1.0 on my custom board...
i install F:\nrf-command-line-tools 、 nRF Connect for Desktop 、 toolchain manager v0.10.3、 finally install "nrf connect SDK v1.91" in F:/ncs
and Follow a video tutorial...
Is there an app note detailing the QFN48 package for the nRF52840, including solder paste recommendations?
The only documentation I've found are the reference gerbers?
Hello,
I am developing FW for a BLE Peripheral on NRF52840_DK using nRF Connect SDK v1.9.1 on VScode.
So far, Peripheral and Client are able to connect and exchange...
Following example in the nRF52810 product specification V1.3. The three LEDs are connected to PWM and waveform is configured in decoder. This means the first 3 values are...
We want to understand any surprises with using nPM1100 on existing or future products.
I just bought two nPM1100-EK units and finished the first round of my evaluation....
Hi,
The customer just wants to realize the function of transparent transmission. Considering the cost, he wants to use nRF52810 to design a two-layer board. Is this feasible...
Hi there,
I am wondering about the range of sniffed frequency band in nRF Sniffer.
The assumed scenario is two nrf52dk set up a connection between themselves, with an...
Hello All,
I am newbie and trying to sniff BT mesh logs using wireshark with nrf52840 dongle. I was successfully able to sniffer the wireshark packets for BT mesh. But currently...
Hello.
I want to know maximum number of 'BLE MESH' connect, Could you teach maximum number in 52840? also Could you teach number of evaluation in 52840?
Thank you.
